• 4A0-110题库demo免费下载

  Filed under Alcatel Lucent
  Aug 3

  Alcatel Lucent认证4A0-110考试题库介绍

  考试代号: 4A0-110
  问题数量:40 Q&As
  
  更新时间: 2009-09-28
  注册地点: Prometric/Pearson VUE
  题库全称:Alcatel-Lucent Advanced Troubleshooting

  免费4A0-110题库Demo赏析

  　
  　
  Exam : Alcatel-Lucent 4A0-110
  Title : Alcatel-Lucent Advanced Troubleshooting

  1. Two routers are physically connected to each other with ISIS configured. No ISIS adjacency can be found on both routers. Ping works fine on the local and the remote interface addresses on both routers. Review the confguration information shown below.
  Which of the following statements best describe the cause of the problem? Select one answer only.
  A. The ISIS interface level configured does not match the ISIS level capability supported on the routers
  B. The ISIS authentication check is enabled but there is no authentication type and password configured
  C. ISIS Area addresses are not configured on both routers
  D. L1 wide Metrics are disabled on the routers
  E. ISIS Circuit id does not match on Node-1 and Node-2
  Answer: C

  2. The LDP session is not down between Node-1 and Node-2. Based on the following configurations, what is the cause of the problem?
  A. LDP targeted-session is enabled with no service configured
  B. OSPF adjacency is not up between Node-1 and Node-2
  C. Router id is not advertised by OSPF
  D. LDP is disabled on Node-1
  E. Traffic-engineering is not enabled on Node-2
  Answer: C

  3. Two direct connected routers are running RIPv2, neighbors are up but there is no route in the RIP database. Review the configuration information below. What is the potential problem?
  A. System interface is not added to the RIP protocol
  B. No import policy is configured
  C. No export policy is configured
  D. Split-horizon has to be disabled in RIP
  E. Message-size has to be configured with a non-zero value
  Answer: C

  4. L1 ISIS adjacency is up between two routers (Node-1 and Node-2) with MD5 authentication configured. During a maintenance window, an operator was planning to change one of the ISIS hello authentication key from admin to admin123. After removing the hello authentication key from Node-1 (no change on Node-2 side), the ISIS adjacency stayed up. The operator decided to fall back to the original configuration and called Alcatel for support.
  Which of the following statement best describe the cause of the problem? Select one answer only.
  A. The ISIS hello authentication key was not configured properly in the first place, that’s why removing the authentication key does not impact the adjacency
  B. The ISIS authentication key is the same as the hello authentication key, therefore removing hello authentication key does not impact the adjacency
  C. The system interface is missing from the ISIS configuration, therefore ISIS is not working properly even before the change
  D. ISIS hello authentication key is only used for hello packet exchange. It does not affect ISIS adjacency
  E. ISIS hello authentication key is not used to bring up ISIS adjacency when traffic-engineering is enabled on the routers
  Answer: B

  5. Based on the following configuration, which of the following statements are true? Choose all that apply.
  A. No OPSF adjacency found on Node 1
  B. Full OSPF adjacency between Node-1 and Node-2
  C. Full OSPF adjacency between Node-1 and Node-3
  D. Full OSPF adjacency between Node-1 and Node-4
  E. OSPF is enabled on Node 1
  Answer: BE

  6. What are the typical RIP related issues found during troubleshooting?
  A. Interface filters
  B. Broadcast/Multicast mismatch
  C. Area id not match with neighbor
  D. Group name not match with neighbor
  E. Hop count too high
  Answer: ABE

  7. Two routers are physically connected to each other over Ethernet port 1/1/ Review the configuration information shown below. What state should the OSPF neighbor be in?
  A. INIT
  B. EXCHANGE
  C. EXSTART
  D. FULL
  E. No OSPF neighbor
  Answer: E

  8. Which of the following debug statements can be used to troubleshoot if the OSPF adjacency is staying at xstart state? Select two answers.
  A. debug router ospf rtm
  B. debug router ospf packet dbdescr
  C. debug router ospf neighbor
  D. debug router ospf packet hello
  E. debug router ospf spf
  Answer: BC

  9. Two routers are physically connected running ISIS. ISIS L2 adjacency is up and running but L1 adjacency is not up. Review the configuration information shown below:
  Which of the following statement best describe the cause of the problem? Select one answer only.
  A. The ISIS interface level is not configured on both routers
  B. The ISIS interface type should be configured as point-to-point interfaces
  C. ISIS System IDs are not configured on both routers
  D. ISIS Area addresses are not configured on both routers
  E. ISIS level capacity are not configured on both routers
  Answer: D

  10. Two routers are physically connected to each other over Ethernet port 1/1/1. Review the configuration information below. What state should the OSPF neighbor be in?
  A. INIT
  B. EXCHANGE
  C. EXSTART
  D. FULL
  E. No OSPF neighbor
  Answer: D

  11. Node A has an active BGP route 10.1.1.1 in its routing table, but the same route is not found in Node D routing table. Which of the following configurations are required to resolve this problem?
  A. Add Interface X to OSPF on Node B as passive interface
  B. Redistribute interface address Y and Z into BGP
  C. ISIS Enable route-reflection on Node B
  D. Enable next-hop-self on Node C
  E. Enable route-reflection on Node C
  Answer: AE

  12. A SDP is created on Node-2 with the far end address set to Node-3. The SDP stays down on Node-2. Based on the following CLI output from Node 2, what is the caused of the problem?
  A. No LDP link session between Node 2 and Node 4
  B. No LDP link session between Node 4 and Node 3
  C. No LDP link session between Node 1 and Node 4
  D. No LDP link session between Node 3 and Node 2
  E. None of the above
  Answer: B

  免费下载4A0-110题库Demo

  Examsoon提供最新的Alcatel Lucent认证 4A0-110题库，其全名为：(Alcatel-Lucent Advanced Troubleshooting). 在您决定是否购买之前 可以先下载4A0-110题库的部分演示. Examsoon是全球唯一提供所有IT认证考试题库demo免费下载的厂商 ，以下为免费4A0-110模拟测试题的下载链接

  免费的4A0-110题库PDF下载链接

  Alcatel Lucent 4A0-110学习指南

  Alcatel Lucent认证 4A0-110考试已经证明了它在全世界的广泛性和重要性，因此明白这项认证考试的世界各地的人必须具备与认证考试相关领域所需的技能和知识。Alcatel Lucent认证 4A0-110学习指南的目的是检查考生的能力和他对概念的意识。很多时候练习测试4A0-110考试都已经被修改过了，删掉了许多过时的东西，而那些需求是在考试课程。当应用到时候你所学的知识的时候，就会鉴定出你所学到的东西以及对所学知识的应用是多么的恰到好处。Alcatel Lucent认证 4A0-110是在IT行业的知名品牌，所以如果您通过了这样一个知名公司举行的一次考试，你可以想象你将来的事业会做的多么好。

  想要通过这个考试当然存在很多困难。你所要做的就是准备好充足的勇气和信心，而这些都来源与你平时训练的好坏.建议大家可以去Examsoon这个网站看一下，它的4A0-110考试是为了测试您在这方面的知识的掌握程度，最好的部分是它可以使你不断更新你所学的知识，不断进步。如果你知道所有的概念和如何使用他们的时候才是你真正掌握了Examsoon的用意。这门考试检查了您的能力和一旦你通过这次考验你将成为最优秀的人才，其他4A0-110考试的Examsoon结算值得注意的影响就是你的薪水将直线上升这大概也是每个人都希望获得的，所以要找一些好的资源才行。

  Examsoon考题大师4A0-110试题都是考试原题的完美组合，覆盖率95％以上，答案由多位专业资深讲师原版破解得出，正确率100％，只要您使用Examsoon的考试题库参加4A0-110考试，保证您一次轻松通过考试；

  售后服务第一！我们相信要想在当今时代取得成功，必须为广大用户提供全套的周到细致的全程优质售后服务，只有客户满意了，才能发展。客户至上是Examsoon考题大师的一贯宗旨；
  
  

  No Comments

Leave a Reply

You must be logged in to post a comment.