• JN0-532题库demo免费下载

    Filed under Juniper Networks
    Aug 3

    Juniper Networks认证JN0-532考试题库介绍

    考试代号: JN0-532
    问题数量:151 Q&As

    更新时间: 2009-08-23
    注册地点: Prometric/Pearson VUE
    题库全称:Juniper Networks Certified Internet Specialist, FWV (JNCIS-FWV)

    免费JN0-532题库Demo赏析

     
     
    Exam : Juniper JN0-532
    Title : FWV,Specialist(JNCIS-FWV)

    1. Which ScreenOS CLI command is necessary for configuring IGMP on interface ethernet0/1?
    A. set igmp interface ethernet0/1
    B. set multicast interface ethernet0/1
    C. set interface ethernet0/1 igmp router
    D. set igmp interface ethernet0/1 enable
    Answer: C

    2. Click the Exhibit button.
    In the exhibit, which two can be determined about the VPN? (Choose two.)
    A. NAT-traversal is enabled.
    B. The rekey interval is 8 hours.
    C. This device initiated the Phase 1 negotiations.
    D. The certificate used in this exchange is set to never expire.
    Answer: BC

    3. Review the exhibit.
    You’ve been asked to build a route-based hub and spoke network, with policy control for traffic travelling from spoke to spoke. Which two of the following configuration options will meet this requirement? (Choose two.)
    A. Place the spoke tunnel interfaces in the trust zone and create policies on the spokes.
    B. Place the spoke tunnel interfaces in the untrust zone and create policies on the spokes.
    C. Create a single tunnel interface in the trust zone at the hub and enable intra-zone blocking.
    D. Create separate tunnel interfaces at the hub and place them in different zones, then create policies at the hub.
    Answer: BD

    4. Which three statements are true regarding IKE Phase 1? (Choose three.)
    A. Placing the SA proposal list in message 1 is an option.
    B. The digital certificate is used to decrypt the session key.
    C. The DH key exchange is used to validate the session key.
    D. The DH key exchange and digital certificates are both optional.
    E. The proxy-id is used to determine which SA is referenced for the VPN.
    Answer: ABC

    5. Which three OSPF parameters are interface parameters? (Choose three.)
    A. cost
    B. priority
    C. neighbor list
    D. summarization
    E. advertise default route
    Answer: ABC

    6. Click the Exhibit button.
    In the exhibit, what is the source IP address of the multicast traffic?
    A. 236.1.1.1
    B. 10.10.10.1
    C. 20.20.20.10
    D. 20.20.20.200
    Answer: B

    7. What must be enabled to protect Phase 2 key exchanges?
    A. Phase 1 PFS
    B. Phase 2 SHA
    C. Phase 2 3-DES
    D. Phase 2 DH key exchange
    Answer: D

    8. You have entered the command
    set ffilter src-ip 1.1.7.250 dst-ip 10.1.10.5 ip-prot 6
    What will be the resulting output in the debug for which this was created?
    A. If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has TCP as its protocol then it will be captured
    B. If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has UDP as its protocol then it will be captured
    C. If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has TCP as its protocol then it will be captured
    D. If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has UDP as its protocol then it will be captured
    Answer: C

    9. You have configured the following on your device.
    set address trust MyPC 10.1.1.5/32
    set address untrust CorpNet 10.10.0.0/16
    set policy from trust to untrust MyPC CorpNet any permit
    set int tunnel.1 zone untrust
    set int tunnel.1 ip unnumbered int bgroup1
    set ike gateway GW address 1.1.1.1 outgoing-interface e0/1 preshare Secret sec-level standard
    set vpn VPN gateway GW sec-level standard
    The tunnel interface is down, so the VPN cannot function properly. What is the problem?
    A. The policy needs to have the action tunnel.
    B. The VPN needs to be bound to the tunnel interface.
    C. The tunnel interface needs to be placed in the trust zone.
    D. The tunnel interface needs to be associated with the interface in the untrust zone.
    Answer: B

    10. Click the Exhibit button.
    In the exhibit, what is the address of the multicast receiver?
    A. 234.9.8.42
    B. 192.168.10.2
    C. 192.168.20.10
    D. 192.168.20.200
    Answer: D

    11. To which three ScreenOS components can a policy-based routing policy be bound? (Choose three.)
    A. zone
    B. policy
    C. interface
    D. virtual router
    E. virtual system
    Answer: ACD

    12. What must be configured differently for a route-based VPN and a policy-based VPN?
    A. proxy-id
    B. proposals
    C. remote gateway type
    D. binding the tunnel interface
    Answer: D

    13. During main mode negations a failure has occurred while using IKE certificates.
    Which message pair would you review to troubleshoot this failure?
    A. messages 1 & 2
    B. messages 2 & 3
    C. messages 3 & 4
    D. messages 5 & 6
    Answer: D

    14. Which two item pairs are exchanged during Phase 2 negotiations? (Choose two.)
    A. proxy-id, SA proposal list
    B. IKE cookie, SA proposal list
    C. hash [ID + Key], DH key exchange
    D. SA proposal list, optional DH key exchange
    Answer: AD

    15. Which command is used to verify that IGMP is running correctly?
    A. get route igmp
    B. get igmp query
    C. set igmp query interface e0/1
    D. exec igmp interface e0/1 query
    Answer: D

    16. Review the exhibit.
    Which two of the following elements must be configured on the ScreenOS device in order to support PIM-SM? (Choose two)
    A. A multicast control policy
    B. A bootstrap router process
    C. A unicast routing protocol
    D. A static RP
    Answer: AC

    17. Click the Exhibit button.
    Review the exhibit. Track-ip has failed on the device, but the device did not fail over to the second unit in the cluster:
    Why has failover not occurred?
    A. The physical interfaces have not failed.
    B. The track-ip interval is not sufficient to cause failover.
    C. The track-ip address weight is not sufficient to cause failover.
    D. The track-ip address threshold is not sufficient to cause failover.
    Answer: C

    18. Click the Exhibit button.
    In the exhibit, the firewall administrator at the Storefront is complaining that when the communication to the DataCenter1 fails, the preexisting transfers and applications are dropped when the traffic is switched to DataCenter2.
    Which statement explains this behavior?
    A. SYN checking is enabled in the tunnel.
    B. The weight value for the DataCenter2 is too high.
    C. VPN monitor is misconfigured in the DataCenter2.
    D. Phase 1 and Phase 2 negotiations to DataCenter2 did not occur on time.
    Answer: A

    19. Which CLI command identifies the multicast sources visible to your ScreenOS device?
    A. get route pim
    B. get igmp source all
    C. exec pim interface all query
    D. get vrouter trust-vr protocol pim
    Answer: D

    20. You have created a virtual router called VSYSA-vr and made it shareable. You then create the VSYS using the WebUI, telling it to use an existing VR and selecting the VR called VSYSA-vr.
    What is the status of the virtual router after you create the VSYS?
    A. The router will be the default router but will no longer be shared.
    B. The router will be the default router and will still have a shareable status.
    C. The system will not let you use a shared virtual router when you create a new VSYS. The initial virtual router must be private.
    D. The system will not create a private vr for the VSYS but will assign the untrust-vr as the default router. The shared Virtual router will not be the default router.
    Answer: B

    免费下载JN0-532题库Demo

    Examsoon提供最新的JNCIS认证 JN0-532题库,其全名为:(Juniper Networks Certified Internet Specialist, FWV (JNCIS-FWV)). 在您决定是否购买之前 可以先下载JN0-532题库的部分演示. Examsoon是全球唯一提供所有IT认证考试题库demo免费下载的厂商 ,以下为免费JN0-532模拟测试题的下载链接

    免费的JN0-532题库PDF下载链接

    Juniper Networks JN0-532学习指南

    JNCIS认证 JN0-532考试已经证明了它在全世界的广泛性和重要性,因此明白这项认证考试的世界各地的人必须具备与认证考试相关领域所需的技能和知识。Juniper Networks认证 JN0-532学习指南的目的是检查考生的能力和他对概念的意识。很多时候练习测试JN0-532考试都已经被修改过了,删掉了许多过时的东西,而那些需求是在考试课程。当应用到时候你所学的知识的时候,就会鉴定出你所学到的东西以及对所学知识的应用是多么的恰到好处。Juniper Networks认证 JN0-532是在IT行业的知名品牌,所以如果您通过了这样一个知名公司举行的一次考试,你可以想象你将来的事业会做的多么好。

    想要通过这个考试当然存在很多困难。你所要做的就是准备好充足的勇气和信心,而这些都来源与你平时训练的好坏.建议大家可以去Examsoon这个网站看一下,它的JN0-532考试是为了测试您在这方面的知识的掌握程度,最好的部分是它可以使你不断更新你所学的知识,不断进步。如果你知道所有的概念和如何使用他们的时候才是你真正掌握了Examsoon的用意。这门考试检查了您的能力和一旦你通过这次考验你将成为最优秀的人才,其他JN0-532考试的Examsoon结算值得注意的影响就是你的薪水将直线上升这大概也是每个人都希望获得的,所以要找一些好的资源才行。

    Examsoon考题大师JN0-532试题都是考试原题的完美组合,覆盖率95%以上,答案由多位专业资深讲师原版破解得出,正确率100%,只要您使用Examsoon的考试题库参加JN0-532考试,保证您一次轻松通过考试;

    售后服务第一!我们相信要想在当今时代取得成功,必须为广大用户提供全套的周到细致的全程优质售后服务,只有客户满意了,才能发展。客户至上是Examsoon考题大师的一贯宗旨;

Leave a Reply

You must be logged in to post a comment.

 

友情链接 | Examsoon IT 认证考试网 思科认证资源网 思科微軟考古題 IT證照模擬試題 考古題考試模擬軟件 70-649 70-643 70-646 640-802 640-863 e20-340 HP0-085 HP0-A25