• PW0-100题库demo免费下载

  Filed under CWNP
  Aug 3

  CWNP认证PW0-100考试题库介绍

  考试代号: PW0-100
  问题数量:120 Q&As
  
  更新时间: 2009-09-03
  注册地点: Prometric/Pearson VUE
  题库全称:certified wireless network administrator(cwna)

  免费PW0-100题库Demo赏析

  　
  　
  Exam : CENP PW0-100
  Title : certified wireless network administrator(cwna)

  1. You have been hired by ABC Company to troubleshoot their 802.11abgh-compliant, Wi-Fi-certified access point and wireless client devices. After completing a site survey, you identify five neighboring 802.11b access points belonging to XYZ Company; one on channel 1, three on channel 6, and one on channel 11. To best avoid co-channel and adjacent channel interference, what suggested change is most appropriate?
  A. Configure ABC Company’s access point to use channel 1, 802.11g OFDM-only mode, and to operate in PCF mode.
  B. Configure ABC Company’s access point to use channel 3, 802.11g-standard mode, and to use the RTS/CTS protection mechanism all the time.
  C. Configure ABC Company’s access point to use 802.11a with dynamic frequency selection (DFS).
  D. There is no available configuration that would avoid co-channel or adjacent-channel inteference in this situation.
  Answer: C

  2. What is a valid type of lightning arrestor used with 802.11 wireless LANs?
  A. Coaxial arrestor with a metal oxide varistor (MOV) input circuit
  B. Parallel tuned tank-circuit arrestor
  C. Coaxial arrestor with a gas discharge tube
  D. Inductor-based load-sensing arrestor
  Answer: C

  3. While working on a presentation document in a conference room equipped with a wireless network, you notice that, as you turn your laptop in different directions, your wireless signal strength changes. What RF signal property is primarily responsible for this change in signal strength?
  A. The RF signal’s amplitude is changing due to a change in the visual line-of-sight.
  B. The RF signal’s wavelength is being affected by varying antenna gain.
  C. The RF signal’s multipath is changing the amount of RF absorbed by nearby objects.
  D. The RF signal’s phase is oscillating due to electromagnetic interference (EMI).
  E. The RF signal’s polarization is different than the receiving antenna.
  Answer: E

  4. What IEEE documents specify methodologies for seamless roaming between access points?
  A. 802.11j
  B. 802.11d
  C. 802.11F
  D. 802.11s
  E. 802.11N
  F. 802.11r
  Answer: C

  5. What are some common specifications for 802.11 WLAN antennas?
  A. Spectral Purity Rating
  B. Frequency Range in MHz
  C. Impedance in Ohms
  D. VSWR Rating
  E. Return Loss Rating
  F. Polarization
  Answer: BCDF

  6. What word describes an RF signal that bounces off a smooth or coated surface and changes direction?
  A. Diffraction
  B. Reflection
  C. Refraction
  D. Diffusion
  E. Scattering
  Answer: B

  7. What facts should you consider when choosing a spread spectrum technology for your wireless LAN network?
  A. An 802.11b Direct Sequence Spread Spectrum (DSSS) signal offers higher data rates and is less susceptible to narrowband interference than an 802.11 Frequency Hopping Spread Spectrum system.
  B. While 802.11g devices can use either DSSS or OFDM technology, 802.11a devices only support OFDM. Therefore 802.11g devices always use OFDM to communicate with 802.11a devices.
  C. When 802.11b devices are present in an 802.11g BSS, the use of DSSS will diminish network throughput significantly over a purely OFDM environment.
  D. An 802.11g system supporting only the data rates required by the 802.11g amendment can interoperate with 802.11b devices.
  E. 802.11g systems use OFDM technology to obtain speeds equal to 802.11a systems and to communicate with 802.11b devices.
  Answer: CD

  8. What phrase describes the effect of increasing the distance that an RF wave travels when the RF antenna lobe is focused in a desired direction?
  A. Polar Extension
  B. Active Amplification
  C. Beam Compression
  D. Passive Gain
  E. Phased Array Propagation
  Answer: D

  9. Given: A wireless LAN transmitter that emits a 100 mW signal is connected to a cable with a 3 dB loss. If the cable is connected to an antenna with a 10 dBi gain, what is the EIRP at the antenna element?
  A. 50 mW
  B. 250 mW
  C. 500 mW
  D. 750 mW
  E. 1000 mW
  Answer: C

  10. According to the 802.11g amendment, how much separation is required between the center frequencies of non-overlapping ERP channels?
  A. 10 MHz
  B. 11 MHz
  C. 20 MHz
  D. 22 MHz
  E. 25 MHz
  F. 30 MHz
  Answer: E

  11. Which units of measure are used to describe a calculable power quantity?
  A. dB
  B. dBm
  C. dBi
  D. mW
  E. RSSI
  F. dBd
  Answer: BD

  12. Given: ABC University provides wireless access to campus buildings from their Data Center building. ABC has installed a tower on the Data Center building with a sectorized omnidirectional antenna array using 90 of horizontal beamwidth per sector.
  What is the next step in configuring the antenna array?
  A. Calculate Earth Bulge into the System Operating Margin (SOM).
  B. Configuring the downtilt of each antenna in the array.
  C. Providing DC power to each antenna in the array.
  D. Adjusting each antenna’s beamwidths for optimal gain.
  Answer: B

  13. In a long-distance RF link, what statement about Fade Margin is true?
  A. Fade Margin is the amount of signal strength in addition to the Link Budget.
  B. The Fade Margin of a long-distance RF link does not account for antenna gain.
  C. Fade Margin is rarely taken into account on a long-distance RF link.
  D. Fade Margin and Jamming Margin are synonymous, interchangeable terms.
  Answer: A

  14. In 802.11a WLANs, what statements are true concerning the use of Orthogonal Frequency Division Multiplexing (OFDM)?
  A. Six (6) "pilot" sub-carriers are used as a reference to disregard frequency and phase shifts of the signal during transmission.
  B. OFDM transmissions in the lower U-NII band are limited to 40 mW.
  C. 16QAM modulation is used at the 54 Mbps data rate.
  D. The OFDM PHY is divided into two sub-layers, the LLC and PLCP.
  E. Forty-eight (48) sub-carriers are used as parallel symbol transmission paths.
  Answer: BE

  15. What is the most common mount type for installing a wireless LAN antenna to an outdoor mast (pole)?
  A. Suction cups with threaded posts
  B. Perforated radome enclosure
  C. Magnetic mount with bulkhead adapter
  D. U-bolt with base clamp
  E. Tilt-n-swivel universal mount with ratchet adjustment
  Answer: D

  16. What factors affect the propagation distance of an RF signal?
  A. Antenna gain
  B. Receiving station sensitivity
  C. Fresnel zone blockage
  D. Power over Ethernet (PoE) usage
  E. Antenna polarization
  F. Link budget calculations
  Answer: AC

  17. What causes an excessive Voltage Standing Wave Ratio (VSWR) in an 802.11a WLAN?
  A. Mismatched impedance between devices in series with the main RF signal
  B. Reflected DC current on the main RF signal line
  C. Scattered RF signal along the main signal path
  D. Inductance (crosstalk) between adjacent conductors
  Answer: A

  18. What device feature is user configurable for 802.11i-compliant wireless LAN client devices?
  A. 802.1Q Tagging
  B. SNMP Community Strings
  C. TKIP Configuration Parameters
  D. RADIUS Server IP Port
  E. EAP Authentication Type
  Answer: E

  19. Given: XYZ Corporation is experiencing connectivity problems with their existing building-to-building bridge link. A brick wall on the roof of one building is partially blocking the Fresnel Zone, and the connection is dropping many frames. The administrator moves the antenna to an area not obstructed by the brick wall and then realizes the RF cable cannot reach the new location.
  If an RF extension cable is used, what are the likely results?
  A. The data throughput rate will increase because VSWR will decrease.
  B. The Equivalent Isotropically Radiated Power (EIRP) will decrease.
  C. The antenna coverage area will decrease.
  D. The return loss will increase unless the impedance of the RF extension cable is equal to 50% of the antenna impedance.
  E. The likelihood of a direct lightning strike will increase, placing the entire WLAN system at risk.
  Answer: BC

  20. What determines the orientation of an RF wave as it leaves the antenna element?
  A. Propagation Pitch
  B. Polarization
  C. Wave Front Trajectory
  D. Signal Focus Angle
  E. Acclimatization
  Answer: B

  免费下载PW0-100题库Demo

  Examsoon提供最新的CWNP认证 PW0-100题库，其全名为：(certified wireless network administrator(cwna)). 在您决定是否购买之前 可以先下载PW0-100题库的部分演示. Examsoon是全球唯一提供所有IT认证考试题库demo免费下载的厂商 ，以下为免费PW0-100模拟测试题的下载链接

  免费的PW0-100题库PDF下载链接

  CWNP PW0-100学习指南

  CWNP认证 PW0-100考试已经证明了它在全世界的广泛性和重要性，因此明白这项认证考试的世界各地的人必须具备与认证考试相关领域所需的技能和知识。CWNP认证 PW0-100学习指南的目的是检查考生的能力和他对概念的意识。很多时候练习测试PW0-100考试都已经被修改过了，删掉了许多过时的东西，而那些需求是在考试课程。当应用到时候你所学的知识的时候，就会鉴定出你所学到的东西以及对所学知识的应用是多么的恰到好处。CWNP认证 PW0-100是在IT行业的知名品牌，所以如果您通过了这样一个知名公司举行的一次考试，你可以想象你将来的事业会做的多么好。

  想要通过这个考试当然存在很多困难。你所要做的就是准备好充足的勇气和信心，而这些都来源与你平时训练的好坏.建议大家可以去Examsoon这个网站看一下，它的PW0-100考试是为了测试您在这方面的知识的掌握程度，最好的部分是它可以使你不断更新你所学的知识，不断进步。如果你知道所有的概念和如何使用他们的时候才是你真正掌握了Examsoon的用意。这门考试检查了您的能力和一旦你通过这次考验你将成为最优秀的人才，其他PW0-100考试的Examsoon结算值得注意的影响就是你的薪水将直线上升这大概也是每个人都希望获得的，所以要找一些好的资源才行。

  Examsoon考题大师PW0-100试题都是考试原题的完美组合，覆盖率95％以上，答案由多位专业资深讲师原版破解得出，正确率100％，只要您使用Examsoon的考试题库参加PW0-100考试，保证您一次轻松通过考试；

  售后服务第一！我们相信要想在当今时代取得成功，必须为广大用户提供全套的周到细致的全程优质售后服务，只有客户满意了，才能发展。客户至上是Examsoon考题大师的一贯宗旨；
  
  

  No Comments

Leave a Reply

You must be logged in to post a comment.